ipf electronic PY740025, Руководство пользователя

Страница: 63 / 67

MANUAL [ PY740025/26 ]
•
Subject to alteration! Version: 22.10.2018
ipf electronic gmbh • Kalver Straße 25 - 27 • 58515 Lüdenscheid │ Tel +49 2351 9365-0 • Fax +49 2351 9365-19 │ info@ipf.de •
www.ipf.de
63
7 Safety instructions and maintenance
7.1 General safety instructions
Intended use
This product is a precision device and is used for object detection and the preparation and/or provision of
measuring values as electrical quantities for a subsequent system. Unless this product is specially labeled, it
may not be used for operation in potentially explosive environments.
Commissioning
Installation, mounting and adjustment of this product may be performed only by a qualified person.
Installation
For mounting, use only the mechanical mountings and mechanical mounting accessories intended for this
product. Unused outputs must not be wired. In cable versions with unused cores, these cores must be
insulated. Always comply with admissible cable bending radii. Prior to electrical connection of the product, the
system must be disconnected from the power supply. In areas where shielded cables are mandatory, they
must be used as protection against electromagnetic disturbances. If the customer makes plug connections to
shielded cables, an EMC version of the connectors should be used, and the shield must be connected to the
connector housing across a large area.
Caution
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous light exposure.
7.2 Part identification