Note:
The yellow LED indicates the detection of an object, but does not compulsory correspond to the switching output. The
Teach-In function is active for only 5min. after switching on power. The Teach-in procedure is operating with a
ferromagnetic tool as well as with 2 pin of M8-connector (white wire) by connection to operating voltage
(+Ub).
Reset to the factory settings
Touch the blue Teach-LED which is placed at the rear side oft he housing with a
ferromagnetic tool for 6 sec. until all 3 LEDs blink with a frequency of 4Hz and remove
the tool immediately. Following the blue Teach-LED should blink normally and the
sensor removes to factory settings.
connection:
e.g.
VK200375
mounting bracket:
AY000118
Warning: Never use these devices in applications where the safety of a person depends on their functionality.
MANUAL • Subject to alteration! Version:
June 2014
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
│
[email protected] • www.ipf-electronic.com
3
