ww
w
.ip
el
ec
tr
on
ix
.c
om
IPEX
(IP Electronix)
PH232T485Y11
:
User’s Manual
Page 8 of 18
Doc No.: PH232T485Y11-UM-001
16 January 2022
8.
PORT SETTINGS
-
RS-422
To use PH232T485Y11 as a RS-232 to RS-422 converter, it is not required to set a Baud-Rate and DIP-
Switch condition (on the Top Panel), is not important.
-
RS-485
Before using PH485iX as a RS-232 to RS-485 converter, it is necessary to set the DIP-Switch (on the top Panel)
to appropriate state according to the desired Parity and Baud-Rate. PH232T485Y11 supports a wide
range Baud-Rates from 1200 bps to 921600 bps.
Set the DIP-Switch state according to the following table to set the suitable Baud-Rate.
-
Parity
Set the Parity type by the DIP-Switch keys number 1 and number 2 on the device. “None”, “Even”
and “Odd” Parity type are supported by PH485iX. The Parity setting are shown in the following
table.
-
Stop Bit
1 and 2 bits are selectable for Stop Bit according to the following figure:
-
Data-Length
7-Bits and 8-Bits Data-Length are supported by PH485iX. Set Data-Length by key number 4.
