LDP-9208D/9224D/9224DF/9240D
Quick Guide
5
2.
Installation Connecting the Phone
LDP-9200 series have 3 connection ports (refer to following figure). Each port is for connecting to:
Handset, Ear Mic. headset, and the line cable.
Connect the telephone cord (curly cord) to the handset and the other end to the
handset jack at the bottom of the telephone.
Connect the line cable to the port at the bottom of telephone and the other end to the
wall socket.
Connect the Ear Mic. headset to the jack at the bottom of the telephone. To use Ear
Mic. function, press [PGM] +19 and then set ON.
Figure 6 LDP-9200 series Connections
Information about compatibility headset
We can't guarantee other headsets except the headset list posted on the web site.
Regarding Headset compatibility, refer to "Headset list for IP phone" on the web site.
We will update the compatibility list if we finish testing the new one anytime.
2.1 Wall Mount
LDP-9200 series phones can be mounted on the wall as needed. The following instructions describe
the wall mount installation. Note the foot-stand must be removed.
1.
If installed, remove the foot-stand from the Phone and
DSS.
2.
Connect all wiring to the p
hone as described in “Phone
connection
”. Connect the phone side wiring only.
3.
If required, install the DSS console.
4.
Align the wall-mount bracket (ordered separately) over
the back of the phone, then press the bracket onto the
phone applying steady pressure until it clicks into place.
5.
Install the DSS console wall-mount bracket if required, in
the same way as the bracket for the phone.
6.
Mark and drill two 7mm holes for plastic wall anchors (not included).
7.
Insert the two anchors into the holes, and insert and tighten the two screws (not included)