IPCOMM SEC2, Общее руководство по эксплуатации, обслуживанию и установке, Страница: 8 / 12

Subject to alterations Version 1.2
IPCOMM GmbH - 7 - SEC2 Manual
Gundstraße 15 Copyright © 2010 IPCOMM GmbH
91056 Erlangen All rights reserved
Germany
2.3.2 Ethernet Interfaces
The embedded controller features one 10/100 Mbps BaseT (RJ45) Ethernet interface.
Ethernet Port
RJ45 female connector
Pin Signal
1 ETx +
2 ETx -
3 ERx +
4 ERx -
Pin assignment of Ethernet RJ45 interface Figure 7:
2.3.3 Onboard Serial Console Port
The serial console port is used for locally accessing SEC2 by RS232 port. The console port uses the
RJ45 connector and is next to Ethernet port.
Therefore, please be careful to plug in the right
connector!
In addition to the serial console signal, the console RJ45 port also provides GPIO (programmable I/O
signal) function. The GPIO port is CMOS I/O and programmable as digital input or output. Power up
setting is digital input mode with 75K ohm pull up resistor.
SERIAL Console PORT
RJ45 female connector
Pin Signal
1 PIO0
2 TXD
3 GND
4 PIO1
5 PIO2
6 PIO3
7 RXD
8 PIO4
Pin assignment of RJ45 interface of serial console port Figure 8: