17
Before starting any work the machine, unplug the power cable, turn off the water supply and actuate the
spray gun until the pressure has been relieved completely.
11
TROUBLESHOOTING
Fault
Cause
Remedy
Pressure fluctuates or drops
Lack of water
Turn on water supply
Water filter clogged
Clean the water filter on the
pump supply tube.
Motor hums when switched on,
but does not start
Mains voltage too low
Check electrical connection
Spray gun not actuted
On switching on the machine,
engage the gun
Cross-section of extension lead
too small
Use correctly dimensioned exten
-
sion lead, see “Connect machine
to power supply”
Motor will not start when switched
on
Power supply not OK
Check plug, cable and switch
Mains fuse tripped
Resert mains fuse
Motor stops
Motor protection switch tripped
due to motor overheating
Check that power supply
matches appliance voltage, wait
3 minutes, then switch machine
on again
The detergent fails to come out
Clogged injector
Clean the detergent spray nozzle
element
Jet is ineffective, ragged unste
-
ady
Clean the nozzle of the foam
launch
Clean the high pressure nozzle.
Selector sleeve for type of jet
wrongly set
Adjust selector sleeve
Содержание G 129-C
