REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSHES
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
Reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with a new blade, fitting it onto the
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Automatic brush attachment, version with head lift actuator:
position the brush underneath the head, turn the selector to the “OFF” position, press the “SET” button once then press the “+” button, the machine will
complete the brush attachment sequence.
Automatic brush release, version with head lift actuator:
turn the selector to the “OFF” position, press the “SET” button once then press the “-” button, the machine will complete the release sequence.
DAILY MAINTENANCE
Clean the dirty
water tank.
Check that the suction filter
and dirt filter are clean.
Check that the
detergent outlet filter
is clean.
Check that the brushes are
clean. Replace if necessary.
Check that the
squeegee is clean
and the blades are not
worn.
PLDC03881
1
2
FILTER
BATTERY CHARGER ON BOARD
BATTERY CHARGER STAND ALONE
24V