
2
DAILY MAINTENANCE
Empty the dirty water drum through the drain
hose.
Clean the dirty water drum.
Check the suction filter is undamaged and
clean.
Check the detergent tank fill filter is undama
-
ged and clean.
Check the detergent output filter is undamaged
and clean.
Clean the brush.
Check the squeegee is clean and the blades
are not damaged.
Check the battery charge.
To charge, insert the battery charger connector
into the connector alongside the squeegee
lifting lever.
REPLACING THE SQUEEGEE BLADES
•
release the clip;
•
remove the two blade retainers by pushing them towards the outside of the squeegee then extracting them;
•
remove the blade;
•
reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with a new blade, fitting it onto
the screws on the body of the squeegee;
•
reposition the two blade retainers by centring the widest part of the slots over the fixing screws on the squeegee body, then pushing the blade
retainers inwards;
•
fasten the clip;
AUTOMATIC BRUSH ATTACHMENT
Attaching the brush: rest the brush on the floor in front of the machine and centre it with the guard. Lower the head and operate the brush/drive
lever repeatedly until the brush automatically engages on the flange hub. If the operation is not successful, repeat by pressing on the lever again
and repeating the centring.
Removing the brush: raise the machine head by pushing the head lift pedal down and then to the right and operate the brush/drive lever repeatedly.
After operating the lever a few times, the brush is released and falls to the ground.
THE MACHINE DOES NOT COME ON/START UP
CHECK THE BATTERY CHARGE
THE SUCTION MOTOR DOES NOT WORK
CHECK THE DIRTY WATER DRUM IS NOT FULL
CHECK THE DIRTY WATER DRUM LEVEL SENSOR IS NOT BLOCKED/MALFUNCTIONING
THE MACHINE LEAVES THE FLOOR WET
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THERE IS NO DEBRIS IN THE SUCTION HOSE
CHECK THE SUCTION FILTER IS UNDAMAGED AND CLEAN
CHECK THE DETERGENT TANK LID IS CLOSED CORRECTLY
CHECK THE SUCTION HOSE IS CORRECTLY ATTACHED TO THE SQUEEGEE
THE MACHINE LEAVES THE FLOOR DIRTY
CHECK THE TYPE OF BRUSH/PAD IN USE IS SUITABLE FOR THE TYPE OF DIRT AND FLOOR
THE MACHINE LEAVES STRIPES OF WET FLOOR
CHECK THE FLOOR HAS BEEN BRUSHED BEFORE USING THE MACHINE
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THE SQUEEGEE IS CORRECTLY ADJUSTED
PLDC02179