SA 3 Owner Manual
10
Basic Operation
Turning on the unit:
1.
Press ON/STANDBY to turn on the amplifier.
The power amplifier comes on, and the Power LED will illuminate white.
2.
Press the ON/STANDBY button again to set the amplifier to Standby.
The power amplifier will enter Standby mode, and the Power LED will illuminate red.
Analogue Audio Output Jacks:
This unit has one pair of Analogue Audio Output Jacks. This output can be used to send a signal of what is
currently being listened to, to an analogue recording device such as a Tape Recorder.
•
Connect to Recording equipment using Analogue RCA cables (Stereo 2RCA-2RCA):
Subwoofer Pre-Out:
This unit has a single Mono Subwoofer Pre-Out Jack, SUB OUT for connection to an Active (Powered) Subwoofer.
This jack will output a low frequency signal and its level is automatically raised and lowered along with the main
Volume control.
•
Connect to an Active (Powered) Subwoofer using Analogue RCA cable (Mono 1RCA-1RCA):
NOTE:
The SUB OUT Jack is constantly active, and the level is controlled automatically by the main Volume
control.
EN