2x2 Indoor & Outdoor Access Points
Revision: A0-00
42
CONFIDENTIAL
10.1.1.2
DHCP client configuration
If the protocol is set to DHCP client, the device will automatically get the IPv4 address from the DHCP server.
Refer Figure 19: Basic overview of the network interface setup configuration screen to switch protocol and set the
protocol to DHCP client.
Refer the figure below to provide the DHCP client parameters:
Figure 21: Basic overview of DHCP client parameters for general network interface setup
Follow the steps given below to provide DHCP client parameters:
Table 13: List of actions to provide DHCP client parameters
Callout
Name
Description
1.
Protocol
The protocol is set to “DHCP client”. The IPv4 address and
the other parameters will be taken care by the DHCP server.
Enter the following parameters
2.
WLC IPv4 address
Enter the WLC IP address in IPv4 format
3.
AP Host Name
Enter a unique name for the AP
Click “Save” to save the general network setup configuration or click “Reset” to configure the same again.
