ION Air CD Pro, Быстрый старт, Страница: 4 / 40

4
Setup
When setting up your Air CD Pro, please consider the following precautions:
•
Make sure all items listed in Introduction > Box Contents are included in the box.
•
Avoid positioning your Air CD Pro in areas where there is high humidity, high heat, poor ventilation,
excessive dust, or where there will be excessive vibration (which can cause a CD to skip).
•
If you are going to use headphones, lower the volume before you plug in your headphones and wear
them.
•
If you would like to use a diagram as a reference while connecting your devices to Air CD Pro, see the
Connection Diagram on this page.
Using the Antenna
If you are using the built-in FM radio, the Antenna will help Air CD Pro obtain a strong signal.
To use the antenna:
1. Remove the Antenna from the clips that fasten it to the rear panel. Use two fingers to pull the antenna
away from the rear panel; do not pull up or push down on the antenna while it is clipped in.
2. After removing the Antenna from the clips, bend it to the right so that it can stand up straight (as
pictured in the Connection Diagram ). Extend the Antenna by pulling the top of it upward.
3. While listening to the radio, adjust the Antenna to the left and right as needed for good reception.
When you are done with the radio, shorten the Antenna by pressing the top of it down as far as it will go.
Then position the shortened Antenna so that it is lined up between the clips and push it toward the rear
panel until it locks in between the clips.
Connection Diagram
Items not listed under
Introduction > Box Contents are sold separately.
Antenna
Bluetooth
Audio Source
Bluetooth Speaker
CD
Headphones
Auxiliary Device
Antenna Clips
Air CD Pro
Front Panel