11
No. Component
Description
1
Upper Handle with
Release Bar
Pull to slide the LCD module out
Push to slide the LCD module back in
2
LCD Module
After sliding the LCD module out, push the release bar on top of
the handle to flip up the cover, accessing the LCD display
3
LCD Controls
The buttons to control the position and picture settings of the
LCD display are located here
4
LCD On/Off Button Push this button to turn the LCD monitor on and off. The button
lights up when the LCD monitor is off
Note: This button lights up to indicate that the monitor is off, not
the KVM switch
5
Firmware Upgrade
Switch
During normal operation and while performing a firmware upgrade,
this switch should be in NORMAL position.
If a firmware upgrade operation does not complete successfully,
this switch will be used to perform a firmware upgrade recovery.
See Firmware Upgrade Recovery for details
6
Firmware Upgrade
Port
The firmware upgrade cable will be connected to this 3.5mm
audio jack to perform Firmware Upgrade
7
Reset Switch
Located to the right of the Lock LEDs. Press this recessed
switch in with a thin object to perform a system reset
8
Lock LEDs
The Num Lock, Caps Lock, Scroll Lock LEDs are located here
9
Rack Mounting
Tabs
Rack mounting tabs are located at each corner of the unit.
The LCD KVM switch is designed for rack mounting. If the
KVM switch is not rack mounted, make sure to place it on a
completely flat and firm surface before pulling the device in or
out to prevent damage due to uneven force on the module
10
Power LED
Lights green to indicate that the LCD KVM Console is powered ON
11
USB Port
The USB port is available for peripheral sharing with USB devices
(flash drive, CD-ROM drive, etc)
Or a USB mouse for users who prefer to use an external mouse
12
Touchpad
Standard mouse touchpad
13
Keyboard Module
Standard 99-key keyboard
