6.5 Other functions
6.5.1 Change language
1. Click
.
2. Select the desired language. The language changes automatically.
6.5.2 Locate the area with detected motion
First, click
Configuration
>
Validation
: the area with detected motion in detection field 1 turns red and the
area with detected motion in detection field 2 turns yellow. The detection position appears on the left.
6.5.3 Change the admin password
In
Configuration
>
Settings
>
Account
, click
CHANGE PASSWORD
.
6.5.4 Restore factory default settings
In
Configuration
>
Settings
>
General
click
FACTORY RESET
: the configuration parameters are restored to
default settings and the admin password is reset.
WARNING! The factory configuration is not a valid configuration. Therefore, the system goes into
an alarm status. The configuration must be validated, and if necessary modified, through the
Inxpect Safety application by clicking APPLY CHANGES.
For the default values of the parameters, see "Parameters" on page 74.
6.5.5 Identify a sensor
In
Configuration
>
Settings
>
Node ID Assignment
or
Configuration
>
Sensor position
, click
Identify
near
the desired sensor Node ID: the LED on the sensor flashes for 5 seconds.
6.5.6 Change network parameters
In
Configuration
>
Settings
>
Network Parameters
change the IP address, the netmask and the gateway of
the controller as desired.
6.5.7 Change Fieldbus parameters
In
Configuration
>
Settings
>
Fieldbus Parameters
change the First F-Dest-Addr of the controller.
6. Installation and use procedures
LBK System BUS | Instruction manual v1.0 SEP 2020 | LBK-System-BUS_instructions_en v1.0 | © 2020 Inxpect SpA
57
Содержание LBK System BUS
Страница 79: ......