INVT GD310-011P-4-UL, Руководство по эксплуатации

Страница: 42 / 269

GD310-UL series VFD Keypad operation procedure
-34-
No. Name Description
5 Buttons
PRG
ESC
Programming
key
Enter or escape from the first level menu and
remove the parameter quickly
DATA
ENT
Entry key
Enter the menu step-by-step
Confirm parameters
UP key Increase data or function code progressively
DOWN key Decrease data or function code progressively
SHIFT
Right-shift
key
Move right to select the displaying parameter
circularly in stopping and running mode.
Select the parameter modifying digit during the
parameter modification
RUN
Run key
This key is used to operate on the VFD in key
operation mode
STOP
RST
Stop/
Reset key
This key is used to stop in running state and it is
limited by function code P07.04
This key is used to reset all control modes in the
fault alarm state
STOP
RST
Quick key
The function of this key is confirmed by function
code P07.02.
5.3 Keypad displaying
The keypad displaying state of Goodrive310-UL series VFDs is divided into stopping state parameter,
running state parameter, function code parameter editing state and fault alarm state and so on.
5.3.1 Displayed state of stopping parameter
When the VFD is in the stopping state, the keypad will display stopping parameters which is shown in
figure 5-2.
In the stopping state, various kinds of parameters can be displayed. Select the parameters to be
displayed or not by P07.07. See the instructions of P07.07 for the detailed definition of each bit.
In the stopping state, there are 14 stopping parameters can be selected to be displayed or not. They
are: set frequency, bus voltage, input terminals state, output terminals state, PID given value, PID
feedback value, torque set value, AI1, AI2, AI3, HDI, PLC and the current stage of multi-step speeds,
pulse counting value, length value. P07.07 can select the parameter to be displayed or not by bit
and
》
/SHIFT can shift the parameters from left to right, QUICK/JOG (P07.02=2) can shift the
parameters from right to left.