(2) Lift the inverter to suspend it on the installation bracket through
M8 hex socket cap screws;
(3) Finally, fix the inverter with the bracket. For firm installation, the
operators cannot release the device until the inverter is installed on
the bracket firmly.
(4)Fasten the screws.
Figure 4 Installation of inverter
❹
Electrical installation
Figure 5 Electrical wiring of the inverter
OR
Figure 6 Connection of the AC side and the inverter
Below are the electrical wiring steps of the three-phase inverter:
(1) Before connecting the three-phase AC grid cable to the inverter,
take lightning and short circuit protection measures in accordance
with the local electrical safety codes;
(2) As shown in Figure 6, connect and fasten
L1
、
L2
、
L3
、
N (optional)
and PE conductors of the three-phase common grid to AC terminal,
and then connect the terminal to the AC port of the inverter;
(3) Fix and connect the DC output cables of PV board with the
matched DC connectors, and then connect the connectors to the DC
port of the inverter.
❺
Operation
5.1 Inspection before operation
Check as follows before operation:
(1) Detect the voltage of the components is in the allowable input
voltage range of the inverter;
(2) Detect the voltage of the AC port at AC side is normal;
(3) Check the inverter is in good grounding;
(4) Ensure all switches are “off”;
(5) Ensure all electrical safety precautions are clearly-identified on
the installation site.
(6) Confirm the handheld keypad or communication module is in
correct connection.
5.2 Grid-tied operation
Please start the inverter as follows:
(1) Switch on the integrated DC switch;
(2) Use the handheld keypad or communication module to set the
time, date and area of the inverter;
(3) Switch on the breakers at the AC side;
(4) Observe the LED indicators and information displayed on the
LCD
screen.
Run
Green indicator blinks, others off: the inverter is power
on and in self-inspection;
Run
Green indicator on, others off: the inverter is in power
generation after self-inspection----successful commissioning.
“Warn” or “Fault” indicators are on or blinking: the inverter is
power on, but fault occurs.
5.3
Accessories and wiring
The accessories are the handheld terminal, WiFi, ENET and GPRS.
RS485
3
2
1
4
3
2
1
4
-M
RS485 -S
Connect the 485 port of accessories to the RS485-M(4-10kW) or
RS485(12-40kW) port of the inverter; for the ACF inverter,
RS485-M(4-10kW) or RS485(12-40kW) is to the upper PC and
RS485-S(4-10kW) or EXT(12-40kW) is to the ammeter.
5.4 Regular maintenance
Stop the inverter as follows it needs maintenance, inspection and
troubleshooting:
(1) Switch off the breakers at the AC side;
(2) Switch off the integrated DC switch;
(3) Contact with customer service staff or local dealers.
Содержание 4KW
Страница 1: ......
