ADDITIONAL INFORMATION
a) It is normal for condensation to appear on the nozzle of the Fog Machine.
b) A small amount of fog may spray during or after operation.
c) The unit will have to reheat after long bursts of use. The unit will stop operation for a short
period in order to heat up to operating temperature again. While this is happening, fog
cannot be produced. The light on the Receiver will turn on again when the unit is ready to
generate more fog.
MAINTENANCE & SERVICING
Note: Use of fogger liquids not included or those other than SVI Fog Liquid are not
recommended and may result in blockage, leakage, or other damage to the unit.
INSPECTION:
Before each use, check unit for any cracks in the enclosure, remote control, cords, and plugs.
Make sure there are no exposed wires. Do not use if any of the above conditions are found
.
CLEANING:
Should you experience low fog output after many hours of continuous operation or after the
machine has been idle or in storage for a long time, it is recommended to run a cleaning
solution through the system to prevent the accumulation of particles in the heating element.
a. While the unit is unplugged and cool, empty all Fog Liquid from the machine and replace
with a fog machine cleaning solution in the tank. SVI Fog Machine Cleaning Fluid (not
included) is recommended. Plug unit in and allow to warm as usual.
b. Run unit in a well-ventilated area until tank is empty.
c. Cleaning is now complete.
All fog machines are prone to clogging due to the consistency of Fog Liquid and the high
temperatures at which it vaporizes. However a well maintained machine should provide
years of reliable use.
STORAGE:
It is important to remove all fluid from the unit when storing for an extended period of time.
1. When the unit is unplugged and cool, empty all Fog Liquid from the machine. Plug in unit and
allow to warm as usual.
2. Run unit in a well-ventilated area for 10-seconds to confirm tank is empty and dry.
3. Store on a flat, level surface. Keep in a well-ventilated, cool and dry location.
For best performance, operate unit for 10-minutes every 3 months. Follow the Operation
Instructions and Storage instructions accordingly.
FUSE REPLACEMENT
If the Fog Machine does not work at all when it is connected to the power socket, then it is
probably that the fuse has been broken.
