General safety warning:
Please ensure these instructions are fully read and implemented.
Failure to do so may result in injury to the user. Retain in a safe place
for future reference. The product must be installed by a competent
professional onto a surface that is deemed suitable.
Should you see any damage during unpacking or suspect a fault,
do not install the product and contact your supplier immediately.
Products have been tested to a load of 160kg for 60 seconds in
accordance with BS ISO 17966:2016 on a suitable surface.
1. This product must be correctly assembled, installed, and maintained.
2. If installing the product in a showering or bathing area it may need
to be earthed to conform with IEE Wiring regulations for metallic
components within bathrooms. Consult a suitably qualified person
prior to installation.
3. Support rails can be slippery when wet – use this product
with caution.
4. It is recommended that this product is installed by a suitably
qualified, competent person.
5. Only install the product in an area where the mounting surface
is structurally sound. (Strengthening modifications to the fixing
surface may be required.)
6. This product must be secured to the wall using fasteners which are
appropriate to the structural base material.
7. Any screw caps that are used must be securely fixed so that they
cannot be removed during normal usage.
8. Waterproofing is recommended and all fixings used should be none
rusting. Sealant should be applied around the wall contact points
for any products mounted in a shower. If not properly sealed, there
is the potential for water ingress. This may cause the wood to rot,
compromising the structure and safety of the support rail.
9. DO NOT install in fibreglass / acrylic shower enclosures with
insufficient stiffness and strength. The maximum rated load of this
product is 100kg based on the product being fitted to a suitable
surface using appropriate fixings in accordance with BS ISO
17966:201
6.
Disclaimers, Installation and
further safety information:
The Mirror
- Instruction Manual
|
Instructions
1. Remove mirror from the frame
2. Measure and mark out wall fixing points
3. Drill holes in surface to suit wall fixings (Not supplied)
4. Mount the frame to the wall and re-attach mirror.
D
E
A
3
D
A
E
3
©
ANGULAR (Degrees)
LINEAR (+/-)mm
A3
g
D
E
A
3
D
A
E
3
©
ANGULAR (Degrees)
LINEAR (+/-)mm
A3
g
D
E
A
3
D
A
E
3
©
ANGULAR (Degrees)
LINEAR (+/-)mm
A3
g
D
E
A
3
D
A
E
3
©
ANGULAR (Degrees)
LINEAR (+/-)mm
A3
g
Simplified product dimensions
Wall fixing locations
Components that can be recycled
All components
can be recycled
D
E
A
3
D
A
E
3
©
ANGULAR (Degrees)
LINEAR (+/-)mm
A3
g
Additional product image
