Invicta SFI-80, Руководство оператора

Страница: 3 / 18

2
Band Saw Mod. SFI-80
Fastening the Machine to the Floor
To prevent vibration, set the machine correctly on the floor. The spacing
of concrete anchors is shown in figure 2 sketch.
Electrical Connection
The machine name plate supplies the specifications of the motor and
voltage requirements. Check the name plate for the voltage
requirements and cycles (Hz) before connecting the electrical power.
After completing the connection of the power lines, switch the machine
on and off quickly to see if the rotation of the wheel is clockwise while
standing at the operator’s position. If not, reverse any two of three
phases of power line, without changing the internal wiring of the
machine.
NOTE: If the machine has manual star delta starter, turn it to the start
position (star) and as soon as the motor reaches its maximum speed,
change over to the run position. Never do any work with the switch at
the start position.
Lubrication
Your machine requires periodic lubrication as follows:
1. Remove the guard “G” (Page 05). Lubricate the screw “H” with standard grease.
2. The threaded adjustment tee “43” should be lubricated with the same standard grease used for the screw.
3. The top wheel supporting slide “J” (Page 05) should be lubricated with standard grease.
Adjusting the Guide
W.5/8"
15
0
45
130
1030
510 77
0
130
770
100
100
Level
70
Fig. 2
1. To adjust the cutting height, loosen knob “P” (Page 06), then move the guide up to the desired height and
tighten knob again.
2. The screw “S” and “T” (Page 06) are used to adjust the blade guide for blade width and fine tracking.
3. To adjust the top blade guide bearings “Q”, loosen the locking screw “V” (Page 06) with a 3mm Allen
wrench. Adjustment is made by turning the eccentric shafts which the bearings are mounted using a 6mm
Allen wrench. For the axial adjustment “Q”, pull the shafts forward till you met the blade and lock screw.
4. To adjust the lower blade guide, loosen screws “X” (Page 06) with a 3mm Allen wrench until the bearing
lightly touches the saw blade. Then retighten.
NOTE: The guide pins “Y” should center the saw blade. If it is necessary, center the pins to the desired position
and fasten the lock screws again.