Inverto IDL 6640n, Руководство пользователя

Страница: 10 / 58

En
7
Setup
This section explains the most important functions to ensure that you can directly watch television with your new
digital receiver. Please note, additional adjustments may be required.
Note: Do not connect the digital receiver to the main power yet.
Connecting the Antenna and LNB (Low Noise Block) to the digital satellite receiver input
Connect the LNB on the satellite dish antenna directly to the digital receiver using the “LNB in” connector of the
receiver, by means of a coaxial cable. You may use the loop-through connector to connect to a second receiver.
Connecting the TV set
The digital receiver and TV set can be connected by means of a SCART cable (not supplied) or HDMI cable (not
supplied).
Simply connect the two ends of the cable you select to use in connecting the receiver to the TV set. The SCART
connection ensures that audio and video signals are transmitted to the TV set in optimum quality.
The HDMI connection is recommended for HD TV. In case the TV has a HDMI input connector, a special all-digital
interface that provides the highest picture quality, connect the product to the TV with the HDMI cable.
Connecting the Network
The receiver connects to the internet through the internet router or DSL/cable modem in your home. The receiver
can connect to the router or DSL/cable modem via the Ethernet interface or a dedicated USB Wi-Fi dongle adaptor
(not supplied) depending on the interfaces supported by your router or DSL/cable modem equipment.
1.
Connecting via the Ethernet port:
Connect one end of the Ethernet cable to the receiver and the other end to the LAN port at the router or DSL/
cable modem.
2. Connecting via the USB Wi-Fi dongle adaptor
Set the options for the wireless connection settings under the Network section of the Control Panel (available
only when the USB WiFi dongle is connected):
Network Name (SSID): Select the network name of your Wi-Fi access point from the list. •
Security Type (WEP, WPA, WPA2): The receiver supports WEP 40/128bit ASCII, WEP 40/128bit HEX, •
WPA and WPA2. The settings of the security type of the Wi-Fi and the receiver shall be the same.
Password: When using the security type, you must set the password. Enter the same password in the •
Wi-Fi setting menu.
Note: To improve quality of service, keep the distance between the Wi-Fi access point and the receiver close.
Connection to a DVD recorder or video recorder
The DVD recorder or video recorder may be connected to the receiver via a SCART connection.
Note: The A/V output of the DVD recorder or VCR needs to be connected to the TV directly and cannot be
connected to the receiver.
Connection to a hi-fi system
The audio quality of digital TV and radio programmes can be enjoyed even more when reproduced through a hi-fi
audio system.
The receiver is equipped with an optical digital output. If your hi-fi system is equipped with an optical audio input,
you may use an optical cable to connect your hi-fi system to your digital receiver.
Connection to main power supply
After all the connections are done you can connect your digital receiver to power. Just before plugging a power
cable into the wall connector put the power switch, on the rear panel, in position 0 (off).