INVERTO.TV IDLV-5100P, Руководство пользователя

Страница: 16 / 44

12
delivered to the ASI2 output port on the back panel.
Mux TS: The transport stream received from the internal Mux functional block •
will be delivered to the ASI output port on the back panel.
(Mux TS is only valid when the Mux function block is enabled and turned on).
Press <ENTER>-key to save or press <EXIT>-key to scrap. A few seconds after
the source was selected, the TS will be delivered to the ASI output port on the
back panel.
ASI2 The same configuration method as detailed for ASI1 above.
SDI
This menu not available on models IDLV-5100P-10x and -20x.
Embedded Audios: There are 2 options: On and Off.
Closed Caption Mode: Select from SMPTE 708,SMPTE 608, Line 21, and
Auto. The mode of closed caption needs to be selected based on the video res-
olution. SMPTE 708 and SMPTE 608 are more suitable for HD video, SMPTE
608 and Line 21 are for SD. When select Auto, the unit will choose SMPTE 608
for HD video, and Line 21 for SD video.
Note: Before doing the setup, be sure to enable the Closed Caption switch in
the menu Decoder->Video->Closed Caption.
AC-3 Pass Thru CH: Select the channel for AC-3 audio pass through.
You can select Channel 3-4 or Channel 5-6
E t h e r n e t
(IP)
This menu is displayed only on IDLV-5100P-20x and -44x models which set TS/
IP streaming board as “100M Single IN” and IDLV-5100P-43x which set TS/IP
streaming board as “100M Dual Out”.
The parameters listed below must be set to appropriate values for the network
over which the transport stream over IP is broadcasted.
Stream IP Addr: Enter the IP address for streaming IP output of the unit.
Stream Netmask: Enter the network sub mask for the subnet to which the unit
is connected for IP streaming traffic.
Stream Gateway: Set the gateway for the network to which the unit is con-
nected for IP streaming traffic.
Stream Mac Address: Factory-set MAC addresses are guaranteed to unique.
Therefore you cannot configure the address.
Gateway Mac Address: Gateway MAC addresses need to be set if your
unicast target is in another network segment. If the unicast target is in the
same network segment of 5100P, the gateway MAC address should be set to
FF:FF:FF: FF:FF:FF.
If the unit is IDLV-5100P-43x which is set as “100M Dual Out” in the system
menu, two menus will appear and each contains above five setups so you can
set the two IP output separately
TS/IP1: This sub-menu contains five items: Stream IP Addr, Stream Netmask,
Stream Gateway, Stream Mac Address and Gateway Mac Address. The setup
method is the same as above.
TS/IP2:
The same as TS/IP1.
Protocol: Select the protocol for multicast: UDP or RTP.
TS Pkts Per UDP: Set the number of the TS packages encapsulated in one
UDP package. The valid range goes from 1 to 7.
Time To Live: Set the number of the routers over which the TS over IP can be
transmitted. The valid range goes from 1 to 255.
Type of Service: Select the type of service. There are: Normal, Min Monetary
Cost, Max Reliability, Max Throughput or Min Delay optional.
Source: Select the source of the transport stream over IP streaming output.
There are 5 type of source optional: ASI1 Input, ASI2 Input, CI De-encrypted,
TUNER, and Mux TS
Mode: Select the mode of IP stream; you can select DVB or IPTV.