Optidrive E2 Single Phase Output User Guide V3.10
www.invertekdrives.com
22
Pa
ra
m
e
ter
s
6
6.4.
P-00 Read Only Status Parameters
Description
Display range
Explanation
1st Analog input value
0 … 100%
100% = max input voltage
2nd Analog input value
0 … 100%
100% = max input voltage
Speed reference input
-P-01 … P-01
Displayed in Hz if P-10 = 0, otherwise displayed in RPM
Digital input status
Binary value
Drive digital input status
Reserved
0
Reserved
Reserved
0
Reserved
Applied motor voltage
0 … 600V AC
Value of RMS voltage applied to motor
DC bus voltage
0 … 1000V dc
Internal DC bus voltage
Internal Heatsink temperature
-20 … 100 °C
Temperature of heatsink in
°
C
Hours run meter
0 to 99 999 hours
Not affected by resetting factory default parameters
Run time since last trip (1)
0 to 99 999 hours
Run-time clock stopped by drive disable (or trip), reset on next
enable only if a trip occurred. Reset also on next enable after a
drive power down.
Run time since last trip (2)
0 to 99 999 hours
Run-time clock stopped by drive disable (or trip), reset on next
enable only if a trip occurred (under-volts not considered a trip)
– not reset by power down / power up cycling unless a trip
occurred prior to power down
Run time since last disable
0 to 99 999 hours
Run-time clock stopped on drive disable, value reset on next
enable
Drive Effective Switching
Frequency
4 to 32 kHz
Actual drive effective output switching frequency. This value
maybe lower than the selected frequency in P-17 if the drive is
too hot. The drive will automatically reduce the switching
frequency to prevent an over temperature trip and maintain
operation.
DC bus voltage log
0 … 1000V
8 most recent values prior to trip, updated every 250ms
Thermistor temperature log
-20 … 120 °C
8 most recent values prior to trip, updated every 500ms
Motor current
0 to 2x rated
current
8 most recent values prior to trip, updated every 250ms
Software ID, IO & motor ctrl
e.g. “1.00”, “47AE”
Version number and checksum.
“1” on LH side indicates I/O processor,
“2“ indicates motor control
Drive serial number
000000 … 999999
00-000 … 99-999
Unique drive serial number
e.g. 540102 / 32 / 005
Drive identifier
Drive rating
Drive rating, drive type
e.g. 0.37, 1 230,3P-out
Parameter group zero access and navigation
When P-14 = P-37, all P-00 parameters are visible. Default value is 101.
When the user scrolls to P-00, pressing
will display “
XX
”, where
XX
represents the secondary number within P-00. (i.e. 1 to 20).
The User can then scroll to the required P-00 parameter.
Pressing
once more will then display the value of that particular group zero parameter.
For those parameters which have multiple values (e.g. software ID), pressing the
and
keys will display the different values within that
parameter.
Pressing
returns to the next level up. If
is then pressed again (without pressing
or ), the display changes to the next level up
(main parameter level, i.e. P-00).
If
or is pressed whilst on the lower level (e.g. P00-05) to change the P-00 index, pressing <NAVIGATE> quickly displays that parameter
value.
