Invert Paintball HALO B, Руководство пользователя, Страница: 14 / 25

14
!
!
!
Body Reassembly -
1) (Figure 1) Seat drive assembly back into left side shell. There are 2
tabs on the side of the drive assembly. Be sure that these 2 tabs seat into
the slots in the left side shell. Be sure that the sensor wires flow around
the side of the drive assembly, and are not in front of the bottom rear
hole in the shell, otherwise the body screw will destroy these wires. For
ease of reassembly, tape motor/battery wires down onto the upper feed
neck cover as shown.
2) (Figure 2) Slide the back plate and the circuit board together into the
left side shell to prevent breaking the power button on the board. The
shell has a full length groove all around for the back plate, and there
are 2 notches in the corners of the cavity for the circuit board to seat
into. Be sure circuit board is seated into those 2 notches.
3) Seat Lid, lid spring, and lid pin into left side shell.
4) (Figure 3) Close with right side shell. Make sure back plate enters
the upper and lower groove in the right side shell. Make sure motor/
battery wires do not get pinched between the shells, and that the battery
harness wires pass through the slot in the shell into the battery compart-
ment. Make sure the lid pin enters the hole in the right side shell. Tuck
the extra coil of the anti-jam spring under the lip of the right side shell
using a small flat-head screwdriver.
5) Insert and gently tighten the 6 body screws. Do not over tighten.
6) Replace battery pack. Cover with battery door and insert and gently
tighten the battery door screw.
Figure 1
Figure 2
Figure 3