10 Examples
10.1
Step by step Card ID read
1. Wait for 1 in IsNewTag register (1000 Holding Registers).
2. Read Card ID (1002-1005 Holding Registers).
3. Clear IsNewTag flag for enable reader.
10.2
Step by step read operation
1. Select User signaling mode (it can be omitted) for user response.
2. Select MemoryMode and DataMode.
3. If necessary set ReadAuthorization and WriteAuthorization for any block which has not
default key and will be read.
4. Select block by set read flag bits (RunReadFlag) for block which has to be read.
5. Set ReadEnable flag (write 1).
6. Wait for 1 in IsNewTag register.
When tag is detected (IsNewTag=1) then:
7. Read selected memory area from ReadBuffer (4000-).
8. Do some signal to user for responce if not auto selected.
9. Optionally check ReadResultGlobal (2010) for error.
10. Clear IsNewTag flag for enable reader.
11. Go to step 6 for write another tag or do other things.
10.3
Step by step write operation
1. Select User signaling mode (it can be omitted) for user response.
2. Select MemoryMode and DataMode.
3. If necessary set WriteAuthorization for any block which has not default key and will be
write
4. Write selected memory area by WriteBuffer (10000-). RunWriteFlags assigned for
writing block is set automatic when write data to it.
4. Optional set or clear write flag (RunWriteFlag) for block which has to be write or not.
5. Set WriteEnable flag (write 1).
6. Wait for 1 in IsNewTag register.
When tag is detected (IsNewTag=1) then:
8. Do some signal to user for response if not auto selected
9. Optionally check WriteResultGlobal (2011) for error
10. Clear IsNewTag flag for enable reader
11. Go to step 6 for write another tag or do other things.
User manual RFID IND Modbus Mif
Page
21
z
22
[B03]
