
TIPS
• High ambient temperatures have a negative effect on energy use. Keep the larder in a position away from direct sunlight or other
sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as soon as
possible.
• The space between the shelves and the rear wall of the larder compartment must be unobstructed to allow the cool air to
circulate. Therefore don’t place any food items against the back.
• Turn the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3 to 5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To restore
efficiency, replace the gasket.
• Keep the condensor on the rear wall always clean, free of dust or any impurities.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
22
•
English
troubleshooting
7
If your appliance is not working properly, it may be a minor problem, therefore check the following:
Problem
Cause
Solution
Appliance is not functioning; light
does not work
- Appliance is not plugged in
- There is a power failure
- The thermostat is set on
●
- Plug the appliance in
- Check the fuse box
- Set the thermostat on setting 1-5
Temperature inside the larder is
too high or too low
Thermostat has been set
incorrectly
Set the thermostat correctly
Air circulation vents are blocked
Clean the ventilation openings
Water is running out of the
larder
Drain outlet is blocked
Clear the drain outlet with a skewer
Appliance is excessively noisy
Has the appliance been installed
correctly?
Check the installation
Are the pipes at the back touch-
ing or vibrating?
Check it and move the appliance forwards
The inside light is not working
Lamp is defective
Replace the bulb following the instructions
Note:
gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
IKK1221S-1021S-0881S-instructions.indd 22
27-8-2014 9:42:21
Содержание IKK0881S
Страница 2: ...2 IKK1221S 1021S 0881S instructions indd 2 27 8 2014 9 42 13...
Страница 25: ...English 25 5 Figure G Figure F 5 Figure H 5 3 4 6 IKK1221S 1021S 0881S instructions indd 25 27 8 2014 9 42 26...
Страница 30: ...30 IKK1221S 1021S 0881S instructions indd 30 27 8 2014 9 42 27...
Страница 31: ...31 IKK1221S 1021S 0881S instructions indd 31 27 8 2014 9 42 27...