PREPARING THE INSTALLATION OF THE HOSE FOR EXTRACTION MODE
The hose can be installed either via the wall or via the ceiling.
Preparing the installation of the hose via the wall
1. Drill a hole (A) in the wall with a diameter of 160 mm.
Preparing the installation of the hose via the ceiling
1. Drill a hole (A) in the ceiling with a diameter of 160 mm.
2. Make sure that the hole is positioned a minimum of 100 mm (B) from the wall.
PREPARING THE INSTALLATION OF THE MAINS SOCKET
1. Mark the position for the mains socket. Obey these requirements:
a. The width of the mains socket must be the width of the shaft (A) minus 20 mm.
b. The position of the mains socket must be at a minimum of 10 mm (B) below the support of
the shaft and at a minimum of 300 mm (C) above the support of the cooker hood.
INSTALLING THE APPLIANCE
Preliminary requirements
• Screwdriver
Warning:
Two people are required to install the appliance.
Procedure
1. Put the appliance (A) on the screws (B).
2. Open the cover of the appliance.
3. Tighten the screws to fasten the appliance to the wall. Use the screwdriver.
INSTALLING THE HOSE
1. Install the hose (A) to the appliance (B) and to the exhaust opening (C). Use the hose clamps.
INSTALLING THE SHAFT
Preliminary requirements
• Screws Ø 3.9 mm x 9.5 mm (4x)
Procedure
1. Put the shaft (A) on the appliance (B).
2. Move the top part of the shaft up.
3. Install the screws (C).
(Figure 6)
(Figure 7)
(Figure 8)
(Figure 9)
(Figure 10)
(Figure 11)
English
•
31
Содержание AKD8005ZWA
