PASCAL TENTS ASSEMBLY INSTRUCTIONS
6
INSTRUCTIONS
ASSEMBLY
1. Choose a flat even spot where you want to pitch the tent. Make
sure the spot is big enough to do it (check the dimensions given in
a corresponding picture) (Fig. 1).
2. Remove tent from the bag and lay it on the ground.
3. Attach the LED panel or LED light (if available).
4. Make sure the pump valve is in the position ‚pulled – pumping’
(Fig. 2).
5. Use the pump to inflate the product until you feel it is completely
taut (you will hear the sound of the pump changing) (Fig. 3).
6. Disconnect the pipe from the pump from the product, then turn
the pump off (otherwise the air will escape from product) (Fig. 4).
7. Zip the wall and roof with the zipper starting from the center and
heading down (Fig. 5).
8. Anchor the tent to the ground by inserting spike into the rings at
the base (Fig. 6).
9. Clip the first end of the line to the roof and other to the torsion
anchor and hammer it into the ground. Stretch the rope (Fig. 7).
On a hardened ground, secure the tent with ballast bags.
DISASSEMBLY
1. Unfasten all tent walls.
2. Unhook the rope and remove the torsion anchor and spikes from
the base.
3. Unblock the pump valve pressing it tightly and blocking the cen-
tral pin of the valve in the open position. To do this, turn it about
10 degrees right or left.
To remove the air from the product, you can:
• use the pump in ‚pump out’ mode (connect the pumping hose to
the opposite side of the pump). When you remove the air from the
product using a pump, there is no need to block the valve in the
open position as the pump does it automatically. Anyway, by doing
it you will fasten the process of removing the air.
• do it manually by blocking the pump valve in the open position
(press it).
4. Put legs together and start rolling them from inside to the valves.
5. Pack all elements into the transport bag.
Fig. 1
5
m
5
m
6
m
6
m
3
m
3
m
4
m
4
m
Fig. 6
Fig. 7
Fig. 5
Fig. 3
Fig. 4
Fig. 2
