IXZ-650EVB
InvenSense, Inc., 1197 Borregas Ave., Sunnyvale, CA 94089, USA
4
EB-IXZ-0650-00-02
Tel: +1 (408) 988-7339 Fax: +1 (408) 988-8104
©2009 InvenSense, Inc. All rights reserved.
Website: http//www.invensense.com
Special Instructions
Electrostatic Discharge Sensitivity
The IXZ-650 gyro can be permanently damaged by an electrostatic discharge. ESD precautions for
handling and storage are recommended.
Jumper Connector
The IXZ-650 evaluation board is equipped with a jumper connector to control the voltage supplied to the
gyro. When the jumper is located in the “up” or standard position as shown in the picture above, the 5
Volts being supplied to the gyro is regulated to 3 Volts using an on-board regulator. When the jumper is
located in the “down” position, the on-board regulator is bypassed and the gyro is being directly supplied
with the voltage on Pins 9 and 19 of the IC.
Dimensional Drawing
This information furnished by InvenSense is believed to be accurate and reliable. However, no responsibility is assumed by InvenSense for its use, or for any infringements of patents or
other rights of third parties that may result from its use. Specifications are subject to change without notice. InvenSense reserves the right to make changes to this product, including its
circuits and software, in order to improve its design and/or performance, without prior notice. InvenSense makes no warranties, neither expressed nor implied, regarding the information
and specifications contained in this document. InvenSense assumes no responsibility for any claims or damages arising from information contained in this document, or from the use of
products and services detailed therein. This includes, but is not limited to, claims or damages based on the infringement of patents, copyrights, mask work and/or other intellectual property
rights.
Certain intellectual property owned by InvenSense and described in this document is patent protected. No license is granted by implication or otherwise under any patent or patent rights of
InvenSense. This publication supersedes and replaces all information previously supplied. Trademarks that are registered trademarks are the property of their respective companies.
InvenSense sensors should not be used or sold in the development, storage, production or utilization of any conventional or mass-destructive weapons or any other weapons or life
threatening applications, as well as in any other life critical applications such as medical equipment, transportation, aerospace and nuclear instruments, undersea equipment, power plant
equipment, disaster prevention and crime prevention equipment.
©2009 InvenSense, Inc. All rights reserved.
A
B
D
E
E2
D2
L
L1
L2
Dimensions (mm)
A
5.0 ±1.0
D 25.7 ±0.1
E 31.8 ±0.1
L
3.1 ±0.1
L1 3.1 ±0.1
L2 10.2 ±0.1
D2 19.5 ±0.1
E2 18.5 ±0.1
A
SIDE
TOP
Component Distributors, Inc.
1-800-777-7334
www.cdiweb.com
[email protected]
Downloaded from
Downloaded from
Downloaded from
Downloaded from
