Operation
4.5
Installing/Removing Anti-Tippers
WARNING!
–
Anti-tippers are specific to the different seat-to-floor
angles and/or seat-to-floor heights. Refer to the chart
in this section of the manual for correct usage and
adjustment. If these requirements cannot be achieved,
DO NOT use the wheelchair. Contact a qualified
technician. If changing the seat-to-floor height with or
without a change to seat-to-floor angle, the correct
anti-tippers MUST be used to maintain a 11/2 to 2
inch ground clearance.
–
If so equipped, anti-tippers MUST be attached at all
times. Inasmuch as the anti-tippers are an option
for 0° or 3° on this wheelchair (You may order
with or without the anti-tippers), Invacare strongly
recommends ordering the anti-tippers as a safeguard
for the wheelchair user.
–
Anti-tippers MUST be fully engaged and release
buttons fully protruding out of adjustment holes.
–
ALWAYS use anti-tippers. When outdoors on wet,
soft ground or on gravel surfaces, anti tippers may not
provide the same level of protection against tipover.
Extra caution MUST be observed when traversing
such surfaces.
–
Ensure both anti-tippers are adjusted to the same
mounting hole.
To ensure the correct model anti-tipper is used refer to
chart below. Measurements for anti-tippers are approximate
and are taken with extension tube in bottom hole position.
ANTI-TIPPER (MEASUREMENT IN INCHES)
Seat-to-
Floor
Height
Lenght
Height
Model
Part No.
17 1/2
to 19 1/2
inches
13 1/2
3 1/2
1360
1058836
151/2
to 171/2
inches
11 5/8
2 3/4
1360A
1058752
Anti-Tipper Length
Bottom Position
Anti-Tipper
Height
Flat Surface
1.
Press the release buttons
A
and insert the anti-tipper
B
with
the anti-tipper wheels
C
pointing toward the ground/floor into
the anti-rattle and
D
wheelchair frame tubing
E
.
2.
Ensure that the release button of the anti-tipper fully protrudes
out of the hole in the bottom of the wheelchair frame tubing.
3.
Place the wheelchair on a flat surface.
1567855-C
25
Содержание Veranda 4000 series
Страница 5: ...9 2 Usability Survey 45...
Страница 48: ...Notes...