Invacare® TDX® SP
1.
Place the wheelchair in a well ventilated area.
2.
Verify the joystick On/Off switch is in the Off position and
disconnect joystick. Refer to 8.17.1 Disconnecting the SPJ+
Joysticks, page 72 or 8.18.2 Disconnecting the CMPJ+ Joysticks,
page 73.
3.
Remove the rear shroud, front shroud and battery retention
bracket. Refer to 8.8.3 Removing/Installing the Front
Shroud/Battery Retention Bracket, page 62.
4.
Disconnect the controller from the batteries at the rear of the
wheelchair.
5.
Slide battery tray
A
with batteries out.
6.
Disconnect the battery straps
B
.
Battery connection
E
located on top.
7.
Disconnect batteries.
8.
Remove the front
C
battery.
9.
Slide the rear battery
D
forward and remove it from the tray.
8.11.2
Installing Batteries into the Wheelchair
WARNING!
Risk of Serious Injury
Improperly installed battery tray can cause instability
resulting in serious injury.
–
Ensure batteries and battery tray are installed properly
to maintain stability.
Positioning of the batteries into the battery tray is completed
with battery tray positioned in wheelchair and partially
pulled out. Illustrations are shown without the wheelchair
for clarification purposes only.
66
1143190-N-03
