Invacare Storm4 True Track Plus, Руководство пользователя

Страница: 51 / 110

Adjusting the mobility device to the user's seating posture
3. Undo the two Allen screws (6) at the rear on the crossmember
and remove them.
4. Undo the two Allen screws (9) at the front on the seat support
plate and remove them.
5. Loosen the four Allen screws (7) and (8) which are located at the
front and back to the sides of the seat support plate to release
tension so that the plate can be moved more easily. Do not,
however, remove these screws completely.
6. Pull or push the seat support plate (2) the required width. A
scale (3) has been fitted to the bottom part of the seat support.
Use this scale to read off the seat width in centimeters.
7. Repeat these operations on the other side of the seat.
8. Now tighten all the screws again.
5.11.2 Adjusting the seat depth
Also refer to the previous chapter entitled 5.11.1 Adjusting
seat width, page 50.
The seat depth can be adjusted in stages between 380 and
530 mm.
Tools:
•
4 mm Allen key
•
8 mm jaw spanner
•
oblique pliers
•
cable binder
Particular holes in the seat support must be used to the
screws depending on the required seat depth. It may also be
necessary to replace the seat support plate.
1. Please use the following figures and the table to determine which
holes need to be used for the required seat depth, and therefore
whether the seat support plate needs to be replaced or not.
Seat
depth
in cm
Holes used
in front seat
frame order
no.: 1524550 Holes used
in rear seat
frame order
no.: 1524555 Seat
support
plate
required
38 6 & 7 A & B
41 5 & 7 A & C
43 4 & 6 A & C
SHORT
order no.
1526437
43 4 & 6 A & C
46 3 & 5 A & C
48 2 & 4 A & C
MEDIUM
order no.
1526438
48 2 & 4 A & C
51 1 & 3 A & C
53 1 & 2 B & C
LONG
order no.
1526439
2. Adjust the seat depth as described in the following chapter:
- If the seat support plate does not need to be replaced, please
refer to chapter 5.11.3 Adjusting the seat depth without replacing
the seat support plate, page 52.
- If the seat support plate does need to be replaced, please refer
1529686-R 51