
Fitting the Anti Tippers
1. With both anti tippers move to the rear of the chair.
2. Taking the non-wheel end, insert anti tipper into the chair frame directly behind the
motors.
3. Squeeze the spring clip domes protruding from the surface of the anti tip until they are
inside the frame.
4. Slide anti tipper into tube until the spring clip domes pop out of the holes on the frame,
repeat this on the other side.
5. To release anti tippers, squeeze spring clip domes and withdraw the anti tippers.
CAUTION: Anti tippers are to be used at all times, failure to use could cause serious
injury.
Fitting The Batteries
1. With Batteries in Battery Boxes and tray, move to the rear of the chair.
2. Place keyway shaped hole on the battery tray over the bolt on cross bracing under the
chair.
3. Rest rear tray hooks forward of the anti tipper bars. The tray should be latched into
position.
4. Place battery boxes with batteries enclosed on to battery tray black plug to the front,
battery box with the red and black plug first.
5. Connect battery box plugs together (red), strap into place.
6.
Connect the black plug from the front of the battery box to the short loom (aprox.
150mm long with a plug at the either end) connect the other end to the Power Module.
The Power Module is either located on the left or right under the seat at the rear.
6