Invacare® Matrx® Flovair™
6
Part No 1167584
3.3
Removing/Installing the Pelvic Support Layer
Removing the Pelvic Support Layer
1.
Remove cushion from inner and outer
covers. Refer to Removing/Installing the
Cushion Covers on page 5.
2.
Unfasten the front strap, the rear strap (not
shown), and the two side straps.
3.
Lift the existing pelvic support layer and
remove from the foam.
Installing the Pelvic Support Layer
1.
Center the pelvic support layer on the foam
so that the side straps are centered in the
contours on each side of the foam.
2.
Fasten the rear, front, and side straps together
at the bottom of the foam.
3.
Reinstall cushion into inner and outer covers.
Refer to Removing/Installing the Cushion
Covers on page 5.
3.4
Removing/Installing Removable Leg Wedges
1.
Remove the cushion from the inner and outer covers. Refer to Removing/Installing the Cushion
Covers on page 5.
2.
Remove the pelvic support layer. Refer to Removing/Installing the Pelvic Support Layer on page 6.
3.
Remove the front leg wedge from the side of the cushion that requires a lower cushion to floor
height. Save the leg wedge for future use.
4.
Reinstall the pelvic support layer. Refer to Removing/Installing the Pelvic Support Layer on page 6.
5.
Reinstall cushion into inner and outer covers. Refer to Removing/Installing the Cushion Covers on
page 5.
The cushion comes with a fluid/air pelvic support layer.
Side Strap
Foam Contour
Cushion
Front Strap
Pelvic Support Layer
DO NOT over-tighten the straps. The
pelvic support layer MUST be free to
move with the cushion.
This procedure provides 1-inch of lower seat to floor height on one side of the cushion. This
modification allows for easier foot propelling or the accommodation of some hip flexion
limitations.
This modification can be done on either side of the cushion.
Leg wedges secure in place with hook and loop strips.
Top of Cushion
Bottom of Cushion
Hook and Loop Strips
Removable Leg Wedges
