22
The footplates can be raised for front transfers.
- Adjusting the footplate assemblies on the leg
rests: Release the set screw (A) and position
the foot rest assembly at the required height
in the leg rest tube. Tighten set screw (A).
Heel support straps
To finalise the foot position, the rest can be
equipped with heel straps.
The strap cannot be removed and should be repositioned towards the
front when folding back the footplate.
11. Backrest Extension
Figure 43
The backrest extension has two uprights (B) and a
backrest extension upholstery. The locating pegs
should only be fitted to the push handles of the
backrest by a qualified technician.
When refitting, make sure that it is firmly fixed onto
the locations fitted to the backrest tubes. Raise the
head rest assembly to remove it from the tubes of the
recliner backrest.
- Adjustment: No adjustment is required for this extension.However, it can be
removed for transport.
FITTING INSTRUCTIONS BACKREST EXTENSION FOR VEHICLE
TRANSPORT
When transporting the chair the
backrest extension must be secured
to the push handles.
Using a M5 x 30mm Hex Hd screw
and location ring (See photo)
Slide the location ring inside the slot
on the extension tube, and then
feed the Hex Hd screw through the
tube and location ring and firmly
secure to the push handle.
A
B
42
43
