Part No 1145733
3
Formula™ CG Tilt Manual Center Mount Front Rigging
FIGURE 1
Description of Kit
Removing the Existing Front Rigging Support
NOTE:
For
this
procedure,
refer
to
FIGURE 2.
1. Remove
the
two
cap
screws,
two
spacers
and
threaded
block
securing
the
front
rigging
support
to
the
side
rail.
2. Remove
the
existing
front
rigging
support.
3. Repeat
STEP
1
and
STEP
2
on
the
opposite
side.
4. On
the
side
of
the
wheelchair
where
the
release
handle
will
be
mounted,
remove
the
side
rail
end
cap.
NOTE:
T
‐
nut
will
be
installed
on
the
same
seat
rail
that
the
release
lever
will
be
mounted
to.
5. Install
the
T
‐
nut
(not
shown)
into
the
slot
in
the
side
rail.
6. Slide
the
T
‐
nut
rearward.
7. Reinstall
the
side
rail
end
caps.
FIGURE 2
Removing the Existing Front Rigging Support
2
3
4
7
1
5
24
6
2
4
8
9
12
15
10
14
11
20
20
23
22
21
25
19
18
17
16
13
Front Rigging
Supports
Cap Screws
Spacers
Threaded Blocks
Cap Screws
Spacers
NOTE:
Side
Rail
End
Cap
Not
Shown
Slot in Side Rail
