SECTION 6—ARMS
Part No 1127114
57
Compass™XE
and Allegro®
Depth
NOTE:
For
this
procedure,
refer
to
FIGURE 6.16.
1. Remove
the
two
mounting
screws
that
secure
the
arm
pad
to
the
arm
tube.
2. Remove
the
two
socket
screws
that
secure
the
arm
tube
to
the
T
‐
arm
post.
3. Reposition
the
arm
tube
on
the
T
‐
arm
post:
A. Desk
Length
Arms
‐
to
one
of
three
positions
depending
on
the
desired
arm
pad
depth.
B. Full
Length
Arms
‐
to
one
of
five
positions
depending
on
the
desired
arm
pad
depth.
NOTE:
Additional
positions
are
obtainable
by
turning
the
arm
tube
180°.
4. Secure
the
arm
tube
to
the
T
‐
arm
post
with
the
two
socket
screws.
5. Reattach
the
arm
pad
to
the
T
‐
arm
tube
with
the
two
mounting
screws.
6. Repeat
for
the
opposite
side,
if
necessary.
FIGURE 6.16
Adjusting the T-Arms -
Depth
Installing the T-Arm Sockets
NOTE:
For
this
procedure,
refer
to
FIGURE 6.17
on
page
58.
1. Remove
the
rear
wheels
from
the
wheelchair.
If
necessary.
Refer
to
Removing/
Installing
Rear
Wheels
on
page 101.
2. Position
the
T
‐
arm
socket
and
T
‐
arm
clamp
on
the
wheelchair
frame.
NOTE:
The
T
‐
arm
socket
must
be
positioned
on
the
outside
of
the
wheelchair
frame.
3. Install
the
hex
screws
and
washers
through
the
T
‐
arm
clamp
and
T
‐
arm
socket
and
loosely
tighten.
4. Tighten
the
hex
screws
and
washers
that
secure
the
T
‐
arm
mounting
socket
to
the
wheelchair
frame
in
the
following
sequence:
A. Middle
hex
screw
and
washer.
B. Outside
two
hex
screws
and
washers.
5. Continue
to
repeat
STEP
4
until
the
hex
bolts
are
torqued
to
156
inch
‐
pounds.
Socket
Screws
Mounting
Screw
T-arm Post
Mounting
Screw
Arm Tube
Arm
Pad
NOTE:
If
necessary,
turn
arm
tube
180°
to
obtain
two
positions.
