29
6.1.1 Status
Display
NOTE
:
The ON/OFF diode is used as a fault display (status display). Chapter
"
Error Codes and
Diagnostic Codes
"
on page
38
contains an explanation of the error codes.
6.1.2 Battery Charge Display
•
All diodes illuminate: maximum driving range
•
Only red and yellow diodes illuminate: reduced driving range. Recharge the batteries at the
end of your journey.
•
Only red LEDs illuminate/blink, electronics beeps 3x: battery reserve = severely
restricted driving range. Recharge batteries immediately!
NOTE
:
Overdischarge protection: after a certain drive time on reserve battery power the electronics
system switches the drive off automatically and brings the Scooter to a standstill. If you do not
drive your Scooter for a while the batteries will "recuperate" and allow a further, but short,
journey. However, after a very brief journey the red diodes will illuminate again and the electronic
system will beep three times. This procedure leads to battery damage and should be avoided if
possible!
