Invacare® Modulite
Installing Switch
1.
Install parts in reverse order.
2.
Plug in cable.
3.
Test all functions.
5.12.8 Replacing recline actuator
Tools:
•
8 mm Allen key
•
Open-ended spanner, 10 mm
•
Open-ended spanner, 13 mm
Remove recline actuator
1.
Pull cable off directly where it is connected to actuator
(2).
2.
Detach bracket from actuator at top and bottom; to
do this, slide bolts (4) to the side using the lever (5)
and tilt the actuator (2) out of backrest clamp (3).
3.
Replace actuator.
To increase the angle of the backrest, you can
remove the adapter (1). See
Install recline actuator
1.
Install parts in reverse order.
5.12.9 Recline actuator - removing adapter
The Modulite seat is shipped ex works with an adapter on
the backrest actuator, which allows a backrest angle of 75
to 105 degrees. This is done for safety reasons, in order
to ensure tipping stability in cases of heavy user weight
or tall users with a corresponding shift in their center of
gravity. Smaller or lighter users can use the full range of
backrest angles from 90 to 120 degrees.
1.
The adapter (1) must be removed to allow this.
The tipping stability must be checked
afterwards, to determine the safety and
stability of the electric wheelchair. See service
manual, “Checking tipping stability”.
2.
Slide bolts (6) to the side using the lever (5) and tilt
actuator out of the upper bracket.
3.
Remove SL retainer clip (2) incl. washers (3) from the
fixation bolt (4).
4.
Pull fixing bolt (4) out.
5.
Remove adapter (1).
5.13 Replacing Seat Interface/Frame
5.13.1 Replacing seat/seat frame without lifter
TDX SP2; FDX
This chapter describes how to replace the seat
frame on a mobility device without a lifter or tilt
module. To replace a lifter or tilt module, follow
the procedures explained in “Replacing lifter/tilt
module”.
WARNING!
Risk of crushing
The seat is very heavy. Risk of injury to hands
and feet.
– Use proper lifting techniques.
•
6 mm Allen key
•
Torque wrench 5 – 30 Nm (or similar)
•
Protractor
•
Side cutting pliers
•
Cable ties
•
Wooden block
Take careful note of the exact position of the seat.
Mark the position it is mounted in, the angle and
so on. If necessary, make photographs with a digital
camera. Any modification of the adjustment of the
seat affects the centre of gravity of the wheelchair.
38
1604311-G
Содержание AVIVA RX40
Страница 13: ...Setup 4 Insert four screws A 5 Tighten four screws 1604311 G 13...
Страница 43: ...Notes...
