Removing calf plate
1.
If possible, raise lifter to highest position.
2.
If possible, tip wheelchair with tilt module as far
backwards as it will go.
3.
Switch controls system off.
4.
Use 1/64 inch Allen key to loosen and remove both
screws (2).
5.
Remove calf plate (1).
Installing calf plate
1.
Install parts in reverse order.
2.
Using different adjustment holes (3) in calf plate and
in calf plate brackets, calf plates can be mounted at
different heights and widths. This must be adjusted
to fit needs of the user.
5.10.7 Replacing foot plate on center-mounted
legrest (powered and manual)
•
1/64 inch Allen key
•
1/4 inch Allen key
Fig. 5-21
A manual legrest can be seen in illustration. The method
of fixation to seat is almost identical for both legrests.
Removing
1.
If possible, raise lifter to highest position.
2.
If possible, tip mobility device with tilt module as far
backwards as it will go.
3.
Switch controls system off.
4.
Loosen and remove both screws (3).
5.
Replace foot plate (1).
Installing
1.
Install parts in reverse order.
2.
Tighten screws (3) till they are tight enough that
footplate can barely be moved. In area denoted by (2)
there is an adjustment screw that can only be reached
when footplate is swivelled upwards.
3.
Use 1/64 inch Allen key to adjust angle of footplate to
needs of user with this screw.
5.11 Setting Anterior Tilt
The seating system can be set to a predefined anterior tilt.
For TDX SP2 and TDX SP2 Low-Rider:
•
5° anterior tilt wedge which reduces the maximum
possible tilt by 5°
Fig. 5-22 5° anterior tilt
Replacing Tilt Wedge
CAUTION!
Risk of strains from lifting heavy parts!
– Use proper lifting techniques.
•
6 mm Allen key
1.
Remove seat.
2.
Align tilt wedge with holes on module and in the
desired orientation. See graphics above.
3.
Insert screws and tighten.
4.
Align seat with holes on tilt wedge and install.
Replacing Front Shroud
•
5/8 inch Allen key
1.
Fig. 5-23
Remove screws
A
on front shroud
B
.
2.
Pull front shroud upwards and remove it.
3.
Fig. 5-24
Push recessed front shroud
A
down on hooks
B
.
4.
Tighten screws
C
finger-tight.
1604311-G
33
Содержание AVIVA RX40
Страница 13: ...Setup 4 Insert four screws A 5 Tighten four screws 1604311 G 13...
Страница 43: ...Notes...
