Section
2
:
Installation Instructions
Version 1.0
2
Intuicom, Inc.
2 Installation Instructions
Below is a diagram for the recommended installation of the Intuicom RTK Bridge-X utilizing the
equipment noted above.
Diagram 1
2.1
Configuration
•
Configure the Intuicom RTK Bridge-X to connect to GPS/GNSS Reference network
and obtain CMR/CMR+ correction data stream from an appropriate single reference
station, such as a VRS.
•
Configure the resulting RTK correction data to be output from the data port at a
known baud rate (a baud rate of 38400 is recommended).
•
Confirm GPS and cellular antenna (typically a combined antenna with two coaxial
cables with TNC connectors) are connected and placed where they have good sky
view and good cellular signal.
•
Configure the pinout on the Deutsch connector on the RTK Bridge–X to FMX
data/power cable to match the appropriate pin-out. See Pin-out Diagram 1
