Intrinsyc Open-
Q™ 605 SBC User Guide and HW Specification
V. 1.4
5
Copyright Intrinsyc Technologies Corporation
1.
INTRODUCTION
This document applies to the Intrinsyc Open-Q™ 605 SBC.
1.1
Purpose
The purpose of this document is to provide primary technical information and describe the
features, functionality, and electrical and mechanical specifications of the Intrinsyc Open-Q™
605 SBC. In addition, this document will also provide a brief GPIO/BLSP programming guide.
1.2
Scope
This document describes the features, functionality, and electrical and mechanical specifications
of the Intrinsyc Open-Q™ 605 SBC. In addition to that, the document will also cover the
following items:
•
Design guide for interfacing the included expansion interfaces
1.3
Intended Audience
This document is intended for users evaluating or designing products with the Intrinsyc Open-
Q™ 605 SBC.
1.4
Acronyms and Abbreviations
Acronym / Abbreviation
Definition
ANT
ANTenna
BOM
Bill Of Materials
BSP
Board Support Package
BT
BlueTooth
CLK
Clock
CPU
Central Processing Unit
CS
Chip Select
CSI
Camera Serial Interface
DSI
Display Serial Interface
DNP
Do Not Populate
EMI
Electro-Magnetic Interference
EN
ENable
ERM
Eccentric Rotating Mass
ESD
Electro-Static Discharge
FPC
Flexible Printed Circuit
GND
GrouND
GPIO
General Purpose I/O
GPS
Global Positioning System
HDMI
High Definition Multimedia Interface
I2C
Inter-Integrated Circuit
I2S
Inter-IC Sound
INT
INTerrupt
JTAG
Joint Test Action Group
LDO
Low Drop-Out
LNA
Low Noise Amplifier
LRM
Linear Resonant Actuator
LTE
Long-Term Evolution
