Intrinsyc Open-
Q™ 605 SBC User Guide and HW Specification
V. 1.4
23
Copyright Intrinsyc Technologies Corporation
Pin
Signal
Description
11
DSI0_L1_N
DSI Data Pair 1: Negative Channel
12
DSI0_L1_P
DSI Data Pair 1: Positive Channel
13
GND
Ground
14
DSI0_CLK_N
DSI Clock Pair: Negative Channel
15
DSI0_CLK_P
DSI Clock Pair: Positive Channel
16
GND
Ground
17
VREG_WLED
LED String - Positive
18
WLED_SINK1
LED String - Negative
19
GND
Ground
20
I2C Data
I2C Data
21
I2C Clock
I2C Clock
22
GND
Ground
23
VREG_L3B_3P0
3.0V (600mA max)
24
GND
Ground
25
VREG_L11A_1P8 1.8V (150mA max)
26
LCD0_RST_N
GPIO #75 - LCD Reset
27
GND
Ground
28
TS_RESET_N
GPIO #79 - Touch Reset
29
TS_INT_N
GPIO #125 - Touch Interrupt
30
NC
Not connected
3.10
Camera Connectors (J2500, J2501)
Figure 10: Camera connectors (J2500 and J2501, from left to right)
The Open-Q™ 605 SBC allows for two camera modules to be connected at connectors J2500
(CAM/CSI 0) and J2501 (CAM/CSI 2). The development kit supports the KLT KLT-D3MA-
IMX258 V2.0 camera module. This is a 13MP camera module based on the Sony IMX258 MIPI
CSI Camera Sensor. The mating connector is BBR13-30K6417 from Acon. Suggested maximum
mating cycle for this connector is 50 times. Please refer to Section 6.1: Camera Module for more
information.
