Intraphex TD-BMW6PIN-v2, Инструкция по установке

Страница: 9 / 16


ONCE THE PROPER CONNECTIONS HAVE BEEN MADE THE CANBOX LEDS
WILL LIGHT UP. ONE SHOULD REMAIN SOLID AND THE OTHER WILL BLINK
RAPIDLY. THIS IS NORMAL OPERATION. IF YOUR CANBUS WIRES ARE
INCORRECT, NO DAMAGE WILL OCCUR..
INTERFACE INSTALLATION

PLUG IN THE 6 PIN WHITE MOLEX CONNECTOR TO THE INTERFACE. THE
OTHER END WILL PLUG DIRECTLY INTO THE CANBOX, BUT DO NOT PLUG
INTO THE CANBOX UNTILL THE INSTALLATION IS COMPLETED.

PLUG NAVI BOX RGB CONNECTOR INTO THE INTERFACE INTO THE SOCK-
ET LABELED “RGB IN”.

AT THIS PIONT IT WOULD BE A GOOD IDEA TO MAKE SURE YOUR
DIPSWITCHES ARE SET CORRECTLY. SEE THE CHART IN THE FRONT OF
THE MANUAL.

ROUTE THE FACTORY 6 PIN LVDS CABLE (PREVIOUSLY UNPLUGGED
FROM THE MONITOR TO THE DESIRED LOCATION OF THE INTERFACE
AND PLUG INTO THE FEMALE 6 PIN LVDS SOCKET ON THE INTERFACE.

ROUTE THE 6 PIN MALE LVDS CONNECTOR BACK TO MONITOR LOCA-
TION. YOU ARE JUST LOOPING THE 6 PIN LVDS CABLE FROM THE CAR-
>INTERFACE BOX->MONITOR.