3
Operation
1. While using the Video 1 Input, you can press the Power button to turn the monitor ON/OFF
2. While using the Video 2 Input (Backup Camera), you can press the Power button for 1.5 seconds to turn
the monitor ON/OFF, or use a short press to adjust the image brightness.
1. Remove OEM mirror and replace with supplied LCD mirror.
2. Run your wiring harness into the headliner and down the vehicles A-Pillar, making sure to
avoid any factory airbags. Secure your wiring with zip-ties.
3. Make all necessary wiring connections (See wiring diagram)
This system is completely signal sensing, there is no “reverse trigger wire” in the wire harness. Be
sure to use a relay to power your camera, as most vehicle’s reverse lamp wires are now variable
voltage wires, and will cause a fuzzy or distorted image.
Environment Sensor
Standby Indicator
On/Off/Brightness Adjusting
Installation
87
85
86
87a
NA
30
To ACC Input of Camera
GND
Vehicle
Reverse Lamp Wire
ACC Input
(From Vehicle)
Mirror
Camera
Black-Ground
Video 2 (To Camera)
Video 1 (Additional Input)
Black-Ground
Red-Accessory
Red-ACC (From 87 of Relay)
RCA Output to Video
2 Input of Mirror
Installer Notes