Intralox ThermoDrive, Инструкция по эксплуатации

Страница: 66 / 78

12 NUB TOP STYLE SPECIFICS
Belt Splicing System v.2.0
12-1
Avoid Injury.
Keep hands and fingers clear of Frame
edge when opening the Clamping
Fixture.
Contact with hot Heat Wand or Stand
will cause skin burns; use caution.
Wear safety glasses and use caution
when handling knives and trim tools.
Nub Top Overview
Nubs can hinder secure belt end clamping and
make belt trimming difficult.
Figure 12A: Nub Top Samples
When splicing belts with a Nub Top surface,
include these steps in the procedure for best
results.
• Before aligning belt ends, remove nubs at
belt ends to allow proper trimming after
splicing.
• Before aligning belt ends, prepare the Sil-
icone Spacers.
• When aligning belt ends, use Silicone
Spacers to clamp belt ends securely.
Remove Nubs
Use the Skiver to remove all nubs within 0.5"
(12 mm) of each belt end.
Figure 12B: Remove nubs from splicing area
Prepare Silicone Spacers
for Use
Cut four (4) 0.5" (12 mm) lengths of Silicone
Spacer and ensure the remaining two strips fit
between the Grooved Deck Locating Pins.
Figure 12C: Spacers for 42" Clamping Fixture
NUB TOP STYLE SPECIFICS
12