Intra Automation digiflow 515, Инструкция по установке и эксплуатации

Страница: 21 / 47

Gas- and Steam Flowcomputer DigiFlow 515 Operating Manual
21
7 Programming and parameter setting
7.1 Key description
The keys on the front panel of the set have the following functions:
Pict. Name Function at normal operation Function at parameter setting
TOTAL Change between sums and instant
value display. Presets at digit input the actual digit to '0'.
CURSOR Resets if displayed and allowed the
sum counters.
Positions the cursor at number input on
position right.
SCAN Change between display levels ac-
cording to description on p.9. Increase at number input the digit by '1',
else next parameter at same level.
ENTER Without function. Take number, resp. jump into selected
menulevel.
7.2 Configuration of a set
Both the required results entered and the input signal can be subjected to a check with the help of the flow
chart to the parameter setting.
By pressing simultaneaously the TOTAL– and the SCAN–key the configuration mode is entered. Then the
user defined password must be confirmed after input with the ENTER-key. This password is at the new set:
‘
0000 '.
If moving step by step through the levels, always a description of the actual parameter is shown for clarifica-
tion.
To leave this configuration mode, the menu must stepped until the item ' Leave '. Then the ENTER–key must
be pressed.
7.3 Input of a number
If the input parameter is a number, so the input procedes as follows.
By means of the CURSOR-key is jumped the desired place. This place then is changed with the help of the
SCAN-key. The cursor lies under the sign, this so is changed. The cursor lies under the decimal dot, this so is
moved cyclicly by actuation of the SCAN-key around a place to the right. Lies the cursor under a number, this
can rapidly with the help of the TOTAL-key with the value ` 0 ' be covered.
By pressing the ENTER–key, the number input will be finished.