155A
SAVE THESE INSTRUCTIONS
(155IO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 06/18/2019
English
Page 6
SETUP INSTRUCTIONS (continued)
Installation on Intex Graphite Gray Panel
TM
Pools:
Unscrew the bolts from the section where the LED pool-wall light will be installed, and remove
the clamp covers, the top board and the side boards. Refer to the Panel Pool owner’s manual
for details. For better installation, it is recommended to remove at least 3 side board panels.
Follow above setup instructions 1 to 4.
LONG TERM STORAGE
In areas where freezing temperatures occur, there is risk of ice damage to the product.
It is recommended to remove, clean and store the product in a safe place when
temperature drops below 0 degrees Celsius (32 degrees Fahrenheit).
1
. Unplug the power cord from the electrical socket.
2.
Remove the transmitter
(2)
from the outside of the pool wall first, the pool light
(1)
unit will
automatically float to the surface for easy retrieval, then remove the pool light from the
water.
IMPORTANT: To prevent damage to the transmitter from falling to the ground,
always remove the transmitter first before removing the pool light unit.
3
. If deposits or debris are seen inside the holes of the pool light, use a garden hose to flush
them out. Do not scrape the pool-wall light or use brush to clean it.
4.
Thoroughly air-dry all components before storage.
5.
Store the product and accessories in a dry, temperature controlled location between 0
degrees Celsius (32 degrees Fahrenheit) and 40 degrees Celsius (104 degrees
Fahrenheit).
6
. The original packaging can be used for storage.
4
5
