(187IO) MODEL ZS8220 & ZS8230 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 08/01/2012
187A
SAVE THESE INSTRUCTIONS
Page 21
English
MAINTENANCE
MAINTENANCE (continued)
The 3-Way Test Strips can test the “Free Chlorine”, “pH”, and “Total Alkalinity”
levels at the same time. We recommend that you test the water chemistry weekly,
and maintain the chlorine concentration at 0.5-3 ppm.
Directions and Use
1
. Dip the entire strip into the water and remove immediately.
2
. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3
. Now compare the strip pad to the color chart on the packaging label. If
necessary, adjust the chemical level in the pool water. It is very important, to
use the proper technique when testing the water's chemical level. Read and
follow the written strip instructions carefully.
1
. Disconnect the power cord from the electrical outlet.
2
. After the pool is completely empty, disconnect the Ozone & Saltwater System
from the hoses by reversing the installation instructions.
3
. Air-dry the unit before you store it. This might be a good time to visually inspect
and clean the electrolytic cell.
4
. Store the unit and accessories in a dry place. The temperature should be
controlled, between 32 degrees Fahrenheit (0 degrees Celsius) and 97
degrees Fahrenheit (36 degrees Celsius).
5
. The original package can be used for storage.
INTEX
®
3-WAY TEST STRIPS
(PACKED WITH THE PRODUCT)
LONG TERM STORAGE
4.
In a counter-clockwise motion, unscrew the Titanium electrode nut
(4)
. Pull out
the Titanium electrode
(5)
.
5.
Pour kitchen grade vinegar into a mug to immerse the titanium plates. Soak
them for about one hour and then flush with a garden hose.
6.
Reverse steps 3 and 4 to replace the Titanium electrode
(5)
.