SAVE THESE INSTRUCTIONS
Page 14
NOZZLE & PLUNGER VALVE SETUP
1.
Grasp the nozzle and plunger valve
mechanism.
2.
In a counter-clockwise motion unscrew
plunger valve union from the threaded
strainer connector
(24) (see drawing 5).
Be careful not to lose the step rubber
washer
(21)
. Place the plunger valve on
the ground in a safe place.
3.
In a counter-clockwise motion unscrew the
strainer nut
(22)
from the threaded
connector
(24).
Leave the flat washer
(23)
on the connector
(24)
.
4.
Install the nozzle and plunger valve at the
upper position of the pool inlet. From the
inside of the pool liner insert the
connector
(24)
into one of the pre-cut holes
with the washer remaining on the
connector to be placed against the inside
of the liner wall.
5.
Before assembly, lubricate the threads with
a petroleum jelly. Then, with the flat side of
the strainer nut
(22)
facing the outside wall
of the liner in a clockwise motion screw the
strainer nut
(22)
back onto the threaded
connector
(24) (see drawing 6)
.
6.
Finger tighten the adjustable pool inlet
nozzle
(25)
and the strainer nut
(22)
onto
the threaded connector
(24)
.
7.
Grasp the plunger valve assembly. Make
sure the step washer
(21)
is in place.
8.
In a clockwise motion screw the plunger
valve union back onto the threaded
connector
(24) (see drawing 7)
.
9.
Examine the plunger valve to see if the
handle is pushed fully down to the "0/1"
position. If not,
grasp the handle at
the top and push down turning the handle
in a clockwise direction until the plastic
protruding notch anchors in the "0/1"
position. This will prevent water from
flowing out during filling of the pool
(see
drawings 8.1 & 8.2)
.
10
. Adjust the direction of the nozzle head
pointing away from the pool outlet for a
better circulation result
(see drawing 9)
.
11.
The pool liner is now ready to be filled with
water. Consult the
storable
pool
ownerʼs manual for filling instructions.
