(249IO) MODEL ECO7221/7231 Cartridge Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 04/13/2017
249A
SAVE THESE INSTRUCTIONS
English
Page 10
SALTWATER SYSTEM/FILTER PUMP SETUP
Saltwater System/Filter Pump
1
. Remove the Saltwater System/Filter Pump and hoses from the packaging.
2
. Place the Saltwater System/Filter Pump in a location for hose
(8)
connections to the plunger
valve assemblies. Ensure the Saltwater System/Filter Pump is accessible at all time for
service and maintenance.
NOTE: Some regional regulations may require the filter pump to be mounted on a
stationary platform. There are two mounting holes located in the pump base for this
reason. Consult your local authorities for filter pump mounting requirements.
3
. Grasp the two pump hoses
(8)
and connect the hose nuts to the Saltwater System/Filter
Pump.
4
. In a counter-clockwise motion unscrew the threaded filter housing collar
(3)
from the filter
housing. Place it in a safe place.
5
. The Saltwater System/Filter Pump is an airtight system. In a counter-clockwise motion turn
both air release valves
(1 & 7)
1 - 2 turns to open.
DO NOT remove air release valves as
water will expel with force if the motor is turned on and injury may occur.
6
. Grasp and remove the filter housing cover
(4)
. Check to see if a cartridge is inside the
housing. If yes, replace the cover, finger tighten the housing collar
(3)
back onto the filter
housing.
7.
Gently finger tighten the sediment release valve located at the bottom of the housing to be
sure that water does not leak out.
8
. When the pool is filled connect the hose from the electrolytic cell outlet to the highest strainer
assembly. You will find the hose connection at the bottom of the plunger valve assembly. Use
the hose nut to attach the hose.
9
. Connect the second hose to the middle of the motor housing and to the remaining liner
connection.
IMPORTANT
To prevent air lock, open the lower plunger valve (connected inlet hose) first and then
the upper plunger valve (connected outlet hose). Open air release valves, lift and lower
the inlet hose until water starts to flow out of the air release valves, close air release
valves.
