241A
SAVE THESE INSTRUCTIONS
(241IO) SALTWATER SYSTEM & SAND FILTER PUMP (14” & 16”) ENGLISH 7.5” X 10.3” PANTONE 295U 08/09/2013
English
Page 18
SALTWATER SYSTEM OPERATION (continued)
6
.
Boost cycle
•
If the test result is below 0.1ppm, press and hold “BOOST” button for 5
seconds until the indicator lights up and the LED display display “80”. This
indicates that the saltwater system has started copper ion and more chlorine
sanitizer production. You can press and hold the “BOOST” button for
another 5 seconds until the indicator is off, which will cancel the Boost cycle.
Note:
Once the system has started copper ion and more chlorine sanitizer
production, the boost button can’t be re-set until the power switch is off.
•
The boost operating hours is 8 times the amount of time programmed into the system, i.e. if your
saltwater system operating time is 2 hours, the boost procedure will run 8 x 2 = 16 hours. After
boost procedure has been completed, the system will automatically switch to the normal
working
mode.
•
After a heavy rain or if the pool is dirty, press the “BOOST” button to shock the pool again.
7
.
Test pool water regularly:
Once the copper level appears to be balanced, test the pool water every week to maintain
the proper sanitizer level.
It’s very important that the free chlorine is between 0.5-3 ppm and copper ion concentration is
between 0.1~0.2 ppm. When the copper level is below 0.1 ppm, repeat step 6.
NOTE:
A High copper ion concentration may cause blonde hair to exhibit a green hair. To
prevent this, wear a swimming cap during swimming, and wash hair with special shampoo
after using the pool. See “Troubleshooting Guide”.
8. Stand-by/power saving mode:
•
When the cycle ends, the green “SLEEP” indicator on the control panel lights
up and the LED display flashes “93”. The system is now in Stand-By mode.
After a while, it shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours, starting its daily
cycle of chlorine production.
•
The “SLEEP” indicator stays on, while the system is in the Power Saving
mode. The LED display however, goes blank after 5 minutes. Press any
button ( or ) to view the last LED code.
9. Running the pump alone without the Saltwater System:
To run the pump alone without the Saltwater System function, press and
hold both ( ) and ( ) buttons for 5 seconds until you hear a “beep” and
the LED display shows “FP”. The pump is now operating alone. To stop the
pump, manually turn the switch OFF.
NOTE:
The pump cannot be operated
alone under an automatic timer mode.
IMPORTANT:
To keep the initial automatic operating cycle setting of the
Saltwater System, turn the switch ON, the LED display shows “FP”, then
unlock and lock the keypad controls again, see previous steps 2 and 3.
The LED display shows the initial input hours and the Saltwater System
cycle repeats again.
